Steps and precautions for cleaning rust stains of wire mesh products
In life, we found that stainless steel pots, stainless steel stair railings, stainless steel doors and windows and other stainless steel products are difficult to be corroded, but still can see yellow rust on the surface, which makes everyone very helpless. Here I would like to summarize this stainless steel wire mesh rust and clean experience article.
Steps to clean stainless steel
1. The gentle way to clean stainless steel is to simply wipe the surface with hot water and a clean soft cloth, then use dry metal and other soft cloth to prevent the water spots from being completely removed. I am amazed at how much dirt on the surface is just this step. When using this or any other method, keep in mind that stainless steel has a "grain" metal that runs on the entire surface in one direction and its fine grain, rather than scrubbing it over it. Some people will tell you that this is to avoid scratching the metal or dust, where they can cause rust to form. This is likely to be true, but scrubbing food also seems easier and more effective.
2. If ordinary water leaves some dirt or grease, try adding a mild detergent to the water. The method I used was derived from a natural, biodegradable dishwashing detergent and I found it to be removed with a little bit of water, including some grease. If you clean stainless steel pots or cutlery, this is a better way to use. The food on the cooked food can usually be removed by immersing in soapy water and gently padded with a sponge pad. Don't be impatient, use steel wool, which may scratch stainless steel or leave particles that may rust. Again, remember to rinse and dry the stainless steel after cleaning.
3, the grease can be rubbed on a soft cloth to dissolve alcohol. The grease has been wiped with alcohol all the time, and they disappear completely within a minute or two. Unlike other methods, it is important to rinse off the alcohol and dry it to make it shiny.
4, stubborn or burnt, stains on the surface, can be scrubbed off a soft cloth and paste-like baking soda and water, baking soda is lightly ground, so it is a good idea to test this method on a small, concealed The area of stainless steel makes you believe that you will not have scratches. When I got this step, I was able to remove almost all the stains and discoloration. In fact, I am very happy how it works, I wiped a polishing paste above the stove. Remember to use a soft cloth before drying.
5. If you use all the steps listed above, like me, you may have to wait until after flushing and drying the stainless steel. I used a clean damp cloth to wipe off the residue of the product I used, then rinsed the cloth to wipe the clean water in the second time of the metal. Drying left some streaks, so I sprayed a little metal of the seventh generation of natural glass surface cleaner and wiped it off with a dry cloth. By the way, glass cleaners remove fingerprints from stainless steel that are not dirty and large.
Cleaning stainless steel rust stains
A. When the passive film protective layer is damaged due to scratches, sediments and bleaching agents, the stainless steel does rust.
B. The beginning of rust is small pits and cracks.
C. Use the appropriate tools. Do not use steel, wire brush or scraper.
D. Use a chlorinated alkali detergent at the recommended strength.
E, soften water. Use filters and softeners as much as possible.
F. Immediately wipe off residual moisture containing suspended detergent. Staying on stainless steel for too long can cause rust.
PREVIOUS： Stainless steel wire mesh weaving and characteristics
NEXT：What should I do with the daily care of the stainless steel filter cartridge?
