Do you know what characteristics of stainless steel mesh?
Nowadays, most people are using stainless steel wire mesh. So, what are the benefits of stainless steel wire mesh?
1) Practicality, the development of advanced production skills of stainless steel mesh is an advanced and applicable production skill developed for the needs of a detailed work. It has clear demand-oriented characteristics, and attaches importance to good practice. It is to improve the competitiveness of enterprises and promote the growth of the national economy and improve the inductive strength.
(2) Advancement, the core of the advanced production skills of stainless steel mesh is high quality, high efficiency, low consumption, clean and sensitive technology. It is developed from the traditional production process and completes partial or system integration with new skills. An advanced manufacturing process that is optimized.
(3) Systematic, due to the introduction of microelectronics and information skills, advanced production skills have become a systematic project that can control the material flow, energy flow and information flow of the production process.
(4) Extensiveness, the advanced production skills of stainless steel mesh are the organic blending of traditional production skills, information skills, automation skills and modern management skills, covering the whole process from product design, processing and production to product sales, application and repair, and recovery.
How to deal with the broken wire of stainless steel wire
1. The stainless steel wire enters the factory and begins the heat treatment of the material;
2. Smooth treatment, used to promote the chemical processing process and physical appearance process of stainless steel wire cold processing deformation.
3. Pickling and phosphating, because of the hot-rolled wire or the semi-finished steel wire after heat treatment, the surface has a hard and brittle iron oxide skin layer, and the iron oxide skin affects the smooth coating of the subsequent step on the one hand and cannot be stabilized with the stainless steel wire. The matrix is combined. On the other hand, when the steel wire is drawn, the hardness of the iron oxide scale is high and there is no plasticity, which will scratch the mold and the appearance of the steel wire, and then the iron oxide skin is sandwiched between the mold wall and the steel wire, thereby increasing the friction. In severe cases, it causes broken wires.
4. Drawing, a metal pressure processing method using metal plasticity under the effect of the mold.
Stainless steel wire is easy to break during the stretching process. If the mold is not matched, the wire will be broken. The raw material itself is not good (the quality of the raw material may be bad or the scale of the raw material may be unreasonable). This will not cause the stainless steel wire to stop in the process of production. To avoid the phenomenon of broken wire in the process of production, it is necessary to cut off from the source, the time when the wire material enters the factory should be selected, and the physical properties of each raw material should be stable, otherwise the raw materials should be replaced, so that each There are no mistakes in the process. Use the correct mold, replace the mold in time, adjust the compression ratio before and after, until normal, the mold can be used in the process, can not cut off water or cut off the oil, to ensure that each mold has a smoothing agent. Guarantee its cooling and smoothing effect. In the winter, the temperature is taken into consideration to ensure that the drawing is normal.
PREVIOUS： What should I do with the daily care of the stainless steel filter cartridge?
NEXT：How should I choose stainless steel wire mesh products?
