The stainless steel filter mesh is produced by machine weaving. Sometimes the machine weaving will have a small net disease, which is normal. Sometimes the stainless steel filter is just on the machine, the machine has not been debugged yet. The surface of the stainless steel mesh from the first few rolls will be uneven, with undulating undulations on both sides. How was this caused? How to deal with it? The industry generally refers to it as "the ruffled edge". The reason is that when the machine is just on the machine, the tension of the machine is not adjusted, and the tension is too small. This is a very common net disease.
As a result, an industry has been extended, pulling the net and pulling the net, also called the net, by flattening the stainless steel filter through the tension of the machine. When there is a net disease such as "Ruffled Edge", we will usually send it to a professional drawing machine to flatten the stainless steel filter through the stretching of the machine to solve the problem of "leaf edge".
PREVIOUS： Stainless steel filter is used in the floor heating pre-filter
NEXT：Stainless steel filter mesh physics maintenance knowledge
