The stainless steel mesh is made of such wires as 304, 304L, 316, 310s, etc. The stainless steel mesh has a smooth surface, no rust, and is hygienic and environmentally friendly. Uses: The hospital, pasta and fruit basket series are mainly made of stainless steel wire mesh. After some professional technical treatment, the surface will look brighter and smoother. So, what is the processing of stainless steel mesh?
The stainless steel mesh processing process has the following contents:
1. Stringing process: After cutting a section of wire-wound molding, we will then perform stringing according to the actual requirements of the customer, and finally connect all the formed stainless steel mesh belts together.
2. Edge treatment process: When the stainless steel mesh belt is wound into a series of wires, it is made into a stainless steel mesh belt. After that, it is necessary to dispose of the edges of the series. Generally, it is suitable for the form of use: welding, bending, and screwing. Soldering, adding chains, chain plates, chains, etc.
3, the service life of ordinary mesh belt is very short compared to stainless steel mesh belt, because our use environment is very complex, such as high temperature, corrosion and other environments. As we all know, stainless steel mesh belt is characterized by high temperature resistance, corrosion resistance and high strength.
The stainless steel wire mesh welding process is also very important. The argon arc w
elding process is the most commonly used welding process in stainless steel mesh deep-processed products. Argon arc is a gas shielded welding technique. Is connected around the arc welding
The protective gas is argon to isolate the air outside the weld zone and
prevent oxidation of the weld zone for the purpose of double-sided forming. The technical feature is that the back side of the bead is filled with argon, small current (generally the welding current is about 60A, the current can be manually adjusted), short arc (the arc voltage is below 10V, the voltage is generally not adjustable), and the welding process swings with a zigzag In the way, the temperature between the layers is as high as possible, and the color of the weld is white and yellow. The angle of the argon arc welding torch is 90 degrees and below in the forward direction, and the gap is controlled at about 2 mm.
Whether it is from the processing of stainless steel mesh or welding process, it is very important,
PREVIOUS： Characteristics and inspection of 100 mesh stainless steel wire mesh
NEXT：Teach you to understand 200 micron stainless steel wire mesh
