Mesh Defects Of Paper Making Stainless Steel Mesh

In the process of weaving, paper making stainless steel mesh often have some defects, which are mainly divided into three categories: general defects, main defects and major defects.
MAISHI WIRE MESH MANUFACTURE GROUP is a professional stainless steel wire mesh manufacturer since 1986, now we will talk about the main mesh defects.

1. General mesh defects

The general mesh defects of paper making stainless steel mesh mainly refers to the slight unevenness of the mesh surface, slight rolling, spotted oil stains, small sundries, mild wavy edges, single broken wires, nest wefts, noses, small loose lines, small jumps line, wrong twist, etc. The number of common mesh defects is 10 square meters and cannot exceed 5.

2. Major mesh defects

The main defects of paper making stainless steel mesh refers to:

1) forks, holes (more than 3 broken menstruation);

2) uneven mesh surface;

3) half cut weft (length greater than 50mm);

　　4) thin secret road;

　　5) Lightly wound;

　　6) Lightly inclined;

　　7) Partially wrinkled, creased, corrugated;

　　8) Large jumper (length greater than 10mm);

　　9) Larger loose, double, and parallel (length greater than 30mm) , lotus leaf edge or wavy edge.

　
　3. Serious mesh defects

　　The major defects of paper making stainless steel mesh refers to:

　　(1) The warp and weft are not firmly intertwined, and the two fingers are used to move up and down, and the warp and weft yarns have obvious loose displacement phenomenon;