The stainless steel wire mesh belt is spray-molded, and the stainless steel wire mesh belt spray molding process is very important. The stainless steel wire mesh belt spraying process is described as follows

The procedure for spraying the stainless steel mesh belt is required to be strictly and carefully, otherwise it will affect the quality of the final product. The order of the three steps cannot be reversed, otherwise it will not be completed better.

First, advance the predecessors, then spray, and finally stop boring.

The coating  

isdry and physically boring and chemically boring according to the nature of the coating itself. In practice, it is fast and boring. Solvent-evaporable coatings or heat-curing coatings are often used. The natural boring or simple drying process can achieve the desired effect. The spraying process and method are different depending on the type, performance and curing conditions of the coating. Different Great Wall nets have different pre-disposal methods. Steel parts are mainly used for degreasing, descaling, phosphating, etc., commonly used in liquid decontamination and degreasing, mechanical or chemical derusting, phosphating is to immerse parts in acid dilution (density 1~1.1, PH =1~3), there will be a repercussions at the interface.

When spraying stainless steel mesh belts, pay attention not only to the above, but also to the attention of the sequence of operations. Also pay attention to the usual maintenance is also very important.

PREVIOUS： Stainless steel fabric mesh filtration and problem solving

NEXT：Please pay attention to the magnetic stainless steel wire mesh